7. Ultra limits the warning, when actual temperature <= setting value - 2℃ or >= setting value +2℃, the temperature shows the value twinkle, and sends out " Di Di " Warning sound.
Temp Control ตัวนี้ น่าจะสามารถใช้กับ ชิลเลอร์ และ ฮีตเตอร์ ได้นะครับ
อยู่ที่เราตั้งค่าครับ
ซึ่งวิธีการตั้งค่า น่าจะคือ ข้อ 1
เดี๋ยวลองให้คุณบอยมาแจ้งอีกครั้งครับ
« แก้ไขครั้งสุดท้าย: 26/07/11, [19:49:42] โดย Independent Man »
ขอบคุณมากครับ 7. Ultra limits the warning, when actual temperature <= setting value - 2℃ or >= setting value +2℃, the temperature shows the value twinkle, and sends out " Di Di " Warning sound.
1 temperature setting method: Press "TEMP" button for about 3 seconds, flashes the current set temperature. Press "▲" button , the temperature value by 1, pressing the "down" button, the temperature is decreased by 1; setting range 16-36 ℃. Set up, press the "TEMP" button for 3 seconds to save settings and exit. Such as 15 seconds left did not exit normally or without the right key, it returns the temperature display, change the value is not saved.
2 timer time setting method: according to "TIME" key about 3 seconds, flashes the current setting of boot time, while the first digital tube display below "." Press "▲" key or "down" key to change the original settings, can set the range 0-24H; press the "TIME" button to display the current setting flashes down time and the first digital display below " . " Press "▲" key or "down" key to change change the original settings, setting range 0-24H. Press "TIME" button for 3 seconds to save setting and exit the home. If 15 seconds is not normal or no exit button, it returns the temperature display status, changes in value are not saved.
3 temperature setting see: press "TEMP" button, which displays the current temperature value.For about two seconds after exit.
4 timer view: Press "▲" key to display the current time boot time; press "down" key, displays the current time, time off; for about two seconds after exit.
5 timer strong open, strong off: in the normal monitoring and control state, pressing the "TIME" button, the timer power; again press "TIME" button, disconnect. So the cycle.
6 alarm sounds: a, overrun or over-range alarm by pressing any key to remove the alarm sounds, the probe failure alarm sound can not be eliminated. b, "▲" key and "down" key while holding down three seconds on or off overrun and over-range warning tone function. Alarm tone on prompt "B_o", the alarm sound off tips "B_c". Show Delay 2 seconds after exit.
[Other matters Description] 7. limit alarm, set the value when the measured temperature ≤ or ≥ set value -2 ℃ +2 ℃, the temperature degree indication flashes, and issued a "beep" alarm sound.
8.
9 probe failed to show "EEE", cut off the heater, and issued a "beep" alarm sound.
หน้าหลัก
ค้นหา
บทความ
คำนวณ
ล๊อกอิน
สมัครสมาชิก
Wed 16/Jul/2025
